Hoshizaki “A Superior Degree of Reliability” www.hoshizaki.com Model DT-400BAH-OS Cubelet Icemaker / Dispenser Hoshizaki America, Inc. Issued: 2-28-
10G. Final Checklist 1) Is the icemaker level?2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and
11H. StartupCAUTION1. All parts are factory-adjusted. Improper adjustments may result in failure.2. If the icemaker is turned off, wait for at least 3
12Control Switch("ICE", "OFF" or "DRAIN")Dispense Mode Switch("PORTION" or "CONTINUOUS")Dispense Ice
13I. Controls and Adjustments 1. Portion ControlA variable resistor which controls the amount of ice dispensed is located on the control board.The gu
14III. Cleaning and Maintenance IMPORTANTEnsure all components, fasteners and thumbscrews are securely in place after any maintenance or cleaning is d
158) Allow the icemaker to sit for about 10 minutes before operation. If you placed a clamp on the reservoir hose in step 7, remove it before operatio
168) Move the control switch to the "OFF" position. Remove the upper front, top and left side panels.9) Move the power switch to the "O
17 Fig. 8 Fig. 9B. Cleaning and Sanitizing Instructions - Dispensing ComponentsPerform following the cleaning and sanitizing proce
189) Immerse the parts removed in steps 4 through 8 in the cleaning and sanitizing solutions for about 15 minutes each.10) Rinse these parts thoroughl
19C. MaintenanceIMPORTANT1. This icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker.2
2IMPORTANTOnly qualied service technicians should attempt to install, service, or maintain this icemaker. No installation, service, or maintenance sh
20D. Preparing the Icemaker for Long Storage WARNINGWhen the icemaker is not used for two or three days under normal conditions, it is sufficient to o
21HOSHIZAKI AMERICA, INC. 618 Hwy. 74 S., Peachtree City, GA 30269 USA TEL (770) 487-2331 FAX (770) 487-3360 www.hoshizaki.com 91A2KB10C
3IMPORTANTThis manual should be read carefully before the icemaker is installed and operated. Only qualied service technicians should install, servic
4I. SpecicationsA. Nameplate Rating HOSHIZAKI ICE MAKER MODEL NUMBER DT-400BAH-OSSERIAL NUMBERAC SUPPLY VOLTAGE 115-120/60/1 AMPERES 10.0DESIGN PRESS
5B. Dimensions / ConnectionsUnit: mm [inch]
6II. Installation and Operating InstructionsA. Checks Before InstallationIMPORTANT1. Install in accordance with all applicable national, state, and lo
7C. LocationCAUTION1. This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +45°F to +100°F (+7°C to +3
8E. Electrical ConnectionSee Fig. 2WARNINGThe GREEN ground wire in the factory-installed power cord is connected to a screw on the bracket where the c
9F. Water Supply and Drain ConnectionsSee Fig. 3 CAUTIONTo prevent damage to the equipment, do not operate this icemaker when the water supply is off,
Commenti su questo manuale